The Image Is Skewed.

Causes and solutions for the image being skewed when using the ScanSnap to scan a document are explained below.
Cause

The issue may be caused by the following:

  • Documents skewed during a scan.

  • Documents of different widths and lengths in the same batch were scanned.

Solution
  • When documents may have been skewed during a scan

    When you load the documents, adjust the side guides to the width of the documents.

  • When documents of different widths and lengths in the same batch were scanned

    Align the top of the documents, and load them in the ADF paper chute (cover) as the leading edge. Make sure that all documents are set to the center of the pick roller's width.

    Also, adjust the side guides to the widest document in the batch. The rest of the documents should be set straight to avoid skewing.