Failed to Update the Firmware.
Causes and solutions for when a firmware update fails during the ScanSnap Cloud application setup are explained below.
- Cause
-
The issue may be caused by the following:
Because the network was disconnected while firmware is being downloaded, downloading the data failed.
The computer is not connected to the ScanSnap via a USB cable.
The ScanSnap is turned off.
- Solution
-
Connect the computer to the Internet.
Connect the computer and the ScanSnap with a USB cable.
Turn the ScanSnap off and turn it back on.
If the power is not turned off even after the feed guide is closed, press the [Scan/Stop] button and the WPS button simultaneously with the feed guide closed. The ScanSnap is forced to turn off.
Update the firmware again.