To Continue Scanning

You can continue scanning only when the error message appears in the following cases:

  • For iX1300

    • No document was detected in either the ADF paper chute (cover) of the manual feeder.

    • Paper jam occurred.

    • The ADF top section or the top cover is open.

    • The Carrier Sheet, Photo Carrier Sheet, or Booklet Carrier Sheet has been loaded or inserted.

    • You tapped on [Tap here to cancel] during scanning.

    • A scan was stopped by the paper protection function.

    • Dirt was detected on the document sensor(s).

    • Documents have been loaded in the ADF paper chute (cover) and inserted in the manual feeder.

  • For models other than iX1300

    • No document was detected in the ADF paper chute (cover).

    • Paper jam occurred.

    • The ADF top section or the top cover is open.

    • A Carrier Sheet or Photo Carrier Sheet has been loaded.

    • You tapped on [Tap here to cancel] during scanning.

To continue scanning, perform the following.

  1. Load the remaining pages in the ScanSnap.
    ATTENTION

    Remove any pages inside the ScanSnap.

  2. Tap the [Continue] button to resume the scan.

    Scanning resumes.

    The scanned image is saved when the scanning is completed.