Specifying the IP Address of the ScanSnap to Establish a Connection

When no available ScanSnap is detected, you can connect to the ScanSnap by specifying the IP address of the ScanSnap.

  1. Tap the [Settings] button (for iPhone/iPod touch, Settings Button) on the [File List] screen or do the same thing on the folder screen with the ScanSnap Sync function set to on.

    The [Settings] screen appears.

  2. Tap [Connect to] under [Connect to].

    The [Connect to] screen appears.

  3. Select [Specify IP address] from [Specify directly].

    The [Specify IP address] screen appears.

  4. Enter the IP address of the ScanSnap, and tap the [OK] button.

    Connection is established with the ScanSnap of this IP address.

HINT

The ways to check the IP address of the ScanSnap are as follows:

  • iX1600/iX1500

    Check the IP address of the ScanSnap by displaying the [Wi-Fi settings] screen from the [Settings] screen on the touch panel of the ScanSnap.

  • iX1300/iX500/iX100

    Check the IP address of the ScanSnap with ScanSnap Wireless Setup Tool.

    For details, refer to the ScanSnap Wireless Setup Tool Help.

    For starting ScanSnap Wireless Setup Tool, refer to To Start ScanSnap Wireless Setup Tool.