Connecting the ScanSnap and the Mobile Device by Using the PIN Code of the WPS Function of a Wireless Access Point

To connect the ScanSnap and a mobile device via Wi-Fi, you need to connect the ScanSnap and the mobile device to the same wireless access point. When the wireless access point supports WPS, enter the PIN code for the ScanSnap in the setup window of the wireless access point to connect the ScanSnap to the wireless access point.

After you connect the ScanSnap and the wireless access point, use the application that you installed on the mobile device to connect the ScanSnap and the mobile device.

  1. Set [Wi-Fi connect mode] to [Access point connection] for the ScanSnap.
    1. Press Settings in the home screen on the touch panel of the ScanSnap to display the [Settings] screen.
    2. Press Wi-Fi settings to display the [Wi-Fi settings] screen.
    3. Press [Wi-Fi connect mode] to display the [Wi-Fi connect mode] screen.
    4. Select [Access point connection].
    5. Press Back to return to the [Wi-Fi settings] screen.
    6. Press Back to return to the [Wi-Fi settings] screen.
  2. Connect the ScanSnap to a wireless access point.
    1. Press [Access point connection] to display the [Access point connection] screen.
    2. Press [Access point connect settings] to display the [Connection information configuration method] screen.
    3. Select [WPS (PIN)].
    4. Press the [Next] button to display the [WPS (PIN)] screen.

      Take a note of the PIN that is displayed in the screen in case you forget it.

    5. Open the window for setting the WPS for the wireless access point in a computer or mobile device, and enter the PIN for the ScanSnap.

      The wireless access point is ready to be connected from the ScanSnap.

      HINT
      • For details about the WPS function, refer to the manual of your wireless access point.

    6. Go back to the touch panel of the ScanSnap, and press the [Next] button in the [WPS (PIN)] screen within two minutes.
    7. Press the [Complete] button in the [Check Connection Results] screen.
    8. Press Home to display the home screen.
  3. Check the scanner name of the ScanSnap.
    1. Press Settings to display the [Settings] screen.
    2. Press Connecting Devices to display the [Connecting Devices] screen.
    3. Check the scanner name that is displayed in [Scanner name].
  4. Start up an application on a mobile device, and connect the mobile device to the ScanSnap by using a wireless access point.

    For details about how to connect the mobile device to the ScanSnap, refer to the manual of the application.

    For details about the application that is used on the mobile device, refer to Application Required for a Mobile Device.