A Message Is Displayed, Indicating That This Product Is Already Installed on Your Computer

When you install ScanSnap Home, if a message is displayed, indicating that this product is already installed on your computer, check the following:

Is ScanSnap Home already installed on your computer?

If ScanSnap Home is already installed on your computer, check whether it can run properly.

If ScanSnap Home is not installed on your computer or if you are not able to start up ScanSnap Home normally, uninstall ScanSnap Home and then install ScanSnap Home again in the following procedure.

  1. Use the uninstall tool (SSHomeClean.exe) to uninstall ScanSnap Home manually.

    For details on how to use the uninstall tool, run a search for "SSHomeClean.exe" in ScanSnap FAQ, click the appropriate link that is listed in the search results, and refer to the webpage.

    Before you run the uninstall tool, read "Installation Information Cleanup Guide for ScanSnap Home" that is on the displayed webpage.

  2. If security software is running on your computer, stop it temporarily.

    For details about how to temporarily stop the security software, refer to the manual of the security software that you are using.

  3. Install ScanSnap Home.

    For details, refer to Setting Up the ScanSnap for the First Time.

If the problem still persists, refer to Inquiries Regarding Problems with ScanSnap Home and contact the distributor/dealer where you purchased this product.