1

ADF paper chute (cover)

Open it to use iX500.

Opening it turns on iX500. Then, you can load a document on it.

2

ADF top section

Open it to remove jammed documents, replace the Roller Set, or clean the inside of iX500.

3

Extension

Pull out when scanning long documents.

4

Side guide

Adjust to the width of documents to prevent them from getting skewed.

5

ADF release tab

Pull this tab to open the ADF top section.

6

[Scan] button

Starts scanning. Can be pressed even when the stacker is closed.

Indicates the status of iX500 as follows:

Blue (lit): Ready

Blue (flashing): Scanning

Orange (flashing): Error

7

Wi-Fi indicator

Indicates the connection status between iX500 and your wireless access point as follows:

Blue (lit): Ready

Blue (flashing): Standby

Orange (lit): Not Connectable

Orange (flashing): Not Connectable (WPS error)

8

Stacker

Open to use the stacker.

Stacks up the ejected documents.

9

Tape seal

Remove this tape seal after installing the software.

10

Security cable slot

Used to connect an anti-theft security cable (commercially available).

11

Power connector

Used to connect a power cable.

12

USB connector

Used to connect a USB cable.

13

Ventilation port

Holes for ventilating hot air from inside iX500.

14

WPS button

Press this button to connect to a WPS compatible wireless access point by using the push button method.

15

Wi-Fi switch

Turn this switch on to connect iX500 to a wireless LAN.